Informationen für Assistenten

Advanced Lab Course in Physics

Guidelines for the Assistants

You are assigned to an experiment in the so-called “F-Praktikum”. This document has the objective to provide you with a short job description.

You are supposed to supervise students typically on Fridays during the semester, but it is common practice to offer a few dates during the break before the semester starts to reduce the work load for assistants and students during the semester. Of course this is voluntary for assistants and students. You will be asked for such dates by the convenors of the course.

Supervision:

The supervision mainly comprises the following three topics:
  1. Attestation (Vortestat) (check of student’s knowledge prior to experiment):
    Typical duration: = 60 min., preferably before the experiment starts. Please check if the students understand the essential theory and implementation of the experiment. However, with very good students you might also dwell on related physics etc. If you realize that the students have unacceptable deficits (such that they cannot successfully perform the experiment), send them away for study (ca. 2h), or arrange a new date for the experiment and give them a poor mark (see below).
  2. Supervision of the experiment: You will have to introduce the students to the instrumentation, operation of special devices and programs etc., so that they can perform the experiment. Do not forget to remind the students about safety issues (e.g. LASER safety or other potential hazards). Where appropriate you might also point out pitfalls or how to avoid or repair smaller dysfunctions. Finally the experiment must be critically attended (data, problems etc.) in the lab-book, which you have to sign after completion of the experiment.
  3. Protocol and final discussion: The protocols MUST be handed to you within 2 weeks after completion of the experiment. Extensions to this deadline are only given in case of written excuses (e.g. medical certificate). Otherwise the mark for the protocol (Haupttestat) is ZERO!
    The protocol  should contain:
    • a short summary of the physical principles (only as much as it is needed as a reference for the following analysis, e.g. a short motivation of an used equation)
    • short description of the experiment and how the data were obtained (again mainly as a reference for the analysis)
    • the main part should be on the data analysis (fits, errors, significance and how these were obtained), results and their interpretation.
    • It is not mandatory that the protocol is typeset using a word processing program (can be handwritten as well!).
    • It should be emphasized that a protocol should have less than 20 pages (A4, at least 11 pt font, 2-3 cm margins). You can reject a protocol which exceeds this number.
    • Appendix: References (also to the script, e.g. citing theory and experimentation, etc.), extensive data or graphs as well as a copy of the lab-book should be attached as an appendix, which doesn’t count to the 20 page limit.

    You should correct the protocol after another 2 weeks, and soon after that you are supposed to arrange for another meeting with the students to discuss the protocol, mistakes, etc. and your mark. This mark (Haupttestat) is independent of the first attestation. Both marks should then be entered in the database as soon as possible.

    It would be very helpful, if you send P. Blümler one copy of a poor, average and very good protocol, so that the convenors can check for consistency in marking.

    Plagiarism: In principle the students are allowed to copy passages, pictures, graphs etc. as long as they provide the source (proper citation). In case you spot copies from protocols of other students, books etc. admonish the students and send P. Blümler a short note. In severe cases send the students to the convenors (Oberlack or Blümler).

Marking:

Use the full marking range (0-9 points) and try to be consistent in your judgments.

Students receive a scoring card (Testatkarte), where the marks can be entered on students wish.

Enter the marks as soon as possible in the database of the F-Praktikum (login at http://www-fp.physik.uni-mainz.de/ and go to Eigene Versuche). A template will appear: You  have two slots for each student. Enter the mark of the Attestation (Vortestat) into the first and the mark for the protocol (Haupttestat) into the second slot. Submit them by pressing the button "Eintragen" at the bottom. (Red color means that the marks are overdue). The average of both marks will be the final mark for the experiment.

Marks:

0 =   knowledge and understanding way under the level that can be expected. (experiment cannot be done)
1 =   extensive gaps in the knowledge, so that performing the experiment doesn’t appear reasonable.
2=   extensive gaps in the knowledge, performing the experiment without better preparation makes no sense.
3 =   below average performance with significant shortcomings.
4 =   below average performance with slight shortcomings.
5 =   average performance just under expectation.
6 =   average performance as it can be expected
7 =   above average, good knowledge and comprehension
8 =   way above average, very good knowledge and comprehension.
9 =   excellent knowledge even on related subjects  

 

Passing the F-Praktikum:

Your judgments are the basis for the final mark for the entire lab-course. With an average mark below 5.0 the course is failed. It is also failed if the Haupttestat was marked with zero points twice (e.g. two times missed to turn in the protocol on time). However, in both cases the student may wish to get his/her knowledge checked in a final colloquium which will be arranged by the convenors of the course.

Evaluation sheets:

As soon as available you will find a stack of evaluation forms at each experiment. Please hand one copy to each student (best after finishing the experiment or after the final discussion). The students are supposed to fill them out and drop them in a postbox in front of room 05-630. The forms are only valid for the actual semester. Older forms or copies cannot be analyzed. You can request the results of this evaluation from P.Blümler.

Experiments:

  • Please help us to renovate and correct the scripts: Most of the scripts of part 1 are on the wiki of the lab-course. You and the students can create accounts and correct or contribute to these scripts. This wiki-based concept is still in a testing stage and your help will be greatly appreciated. All experiments with such wikis are equipped with PCs so that the students can check and contribute to the scripts as well. The students’ account (login: FP-User) has no password and only limited privileges. The account FP-Assi  has administration rights. The password can be obtained from P. Blümler.
  • Defect experiments: Please contact P. Blümler.
  • Ideas for improvements: Please contact P. Blümler
  • Please remind the students to leave the experiments neat and clean (No mugs, spoons, bottles, papers etc.)

 

Thank you for your help,

U. Oberlack    Tel.: 25167,     email:

P. Blümler,     Tel.: 24240,     email: